sd
NAME
sd - Driver for SCSI Disk Drives
SYNOPSIS
#include <linux/hdreg.h> /* for HDIO_GETGEO */ #include <linux/fs.h> /* for BLKGETSIZE and BLKRRPART */
CONFIGURATION
The block device name has the following form:
I sd lp,
where
l
is a letter denoting the physical drive, and
p
is a number denoting the partition on that physical drive.
Often, the partition number,
R p ,
will be left off when the device corresponds to the whole drive.
SCSI disks have a major device number of 8, and a minor device number of
the form (16 *
R drive_number ) + partition_number ,
where
drive_number
is the number of the physical drive in order of detection, and
partition_number
is as follows:
partition 0 is the whole drive
partitions 1-4 are the DOS "primary" partitions
partitions 5-8 are the DOS "extended" (or "logical") partitions For example, /dev/sda will have major 8, minor 0, and will refer to all of the first SCSI drive in the system; and /dev/sdb3 will have major 8, minor 19, and will refer to the third DOS "primary" partition on the second SCSI drive in the system. At this time, only block devices are provided. Raw devices have not yet been implemented.
partitions 1-4 are the DOS "primary" partitions
partitions 5-8 are the DOS "extended" (or "logical") partitions For example, /dev/sda will have major 8, minor 0, and will refer to all of the first SCSI drive in the system; and /dev/sdb3 will have major 8, minor 19, and will refer to the third DOS "primary" partition on the second SCSI drive in the system. At this time, only block devices are provided. Raw devices have not yet been implemented.
DESCRIPTION
The following
R ioctl s
are provided:
HDIO_GETGEO
Returns the BIOS disk parameters in the following structure:
struct hd_geometry {
unsigned char heads;
unsigned char sectors;
unsigned short cylinders;
unsigned long start;
};
A pointer to this structure is passed as the
ioctl(2)
parameter.
The information returned in the parameter is the disk geometry of the drive
as understood by DOS!
This geometry is
not
the physical geometry of the drive.
It is used when constructing the
drive's partition table, however, and is needed for convenient operation
of
fdisk(1),
efdisk(1),
and
lilo(1).
If the geometry information is not available, zero will be returned for all
of the parameters.
BLKGETSIZE
Returns the device size in sectors.
The
ioctl(2)
parameter should be a pointer to a
R long .
FILES
/dev/sd[a-h]: the whole device
/dev/sd[a-h][0-8]: individual block partitions
/dev/sd[a-h][0-8]: individual block partitions
